8 Getting started
2.2 Parent unit battery installation
1. Turn the belt clip so that it is in the hanging position.
2. Loosen the screw in a counterclockwise direction using a small
screwdriver. Remove the battery cover.
3. Insert the wire tab of the rechargeable battery pack into the
contact slot as shown above and fit the battery pack into the
compartment.
4. Close the battery compartment and tighten the screw in a
clockwise direction.
5. Press
F to turn ON the parent unit. In a few seconds the LCD
screen will illuminate and the unit will be ready.
6. Press and hold F to turn OFF the parent unit.
The battery icon indicates that the battery pack is low and needs
to be recharged. The battery pack takes about 16 hours to charge fully.
NOTE
When the main power is connected, the charge icon is displayed
and the battery icon also displays while the battery is charging.
Black
Red
screw
To Next Page
Loading...
