Motorola MC40 User Manual (English)

Other manuals for Motorola MC40

User Manual166 pages

Integrator Guide203 pages

User Guide126 pages

Questions and Answers:

B
blackburnrandyAug 1, 2025
What to do if Motorola Handhelds MC40 does not turn on but the Decode LED blinks red?
- D
  Diane HillAug 1, 2025
  If your Motorola Handhelds MC40 doesn't turn on when you press the power button, but the decode LED blinks red, it could be due to a very low battery charge. Try recharging or replacing the battery. It's also possible the battery didn't charge properly, in which case replacing it might help. Also, ensure the device wasn't removed from the cradle during charging; a full charge takes about four hours. Lastly, extreme temperatures can prevent charging, so ensure the ambient temperature is between 0°C (32°F) and 40°C (104°F).
M
Matthew AyersAug 6, 2025
Why does my Motorola Handhelds MC40 turn off by itself?
- M
  Melinda VaughnAug 6, 2025
  If your Motorola Handhelds MC40 turns off unexpectedly, it might be due to inactivity, causing the display to turn off. You can adjust the inactivity timeout period to 15 seconds, 30 seconds, 1, 2, 10, or 30 minutes. Alternatively, the battery might be depleted, so try recharging or replacing it.
D
Deborah GarciaAug 12, 2025
How to fix Motorola Handhelds MC40 that does not turn on?
- S
  sarah35Aug 12, 2025
  If your Motorola Handhelds MC40 doesn't turn on when you press the power button, it could be due to several reasons. First, the battery might be completely discharged, so try recharging or replacing it. Second, ensure the battery is installed properly. Third, make sure you're holding the power button down long enough until the right LED flashes. Finally, if the device is unresponsive, try performing a hard reset.
M
Monica LawsonAug 19, 2025
What to do if Motorola MC40 Handhelds data transmission is incomplete?
- C
  Christine BrownAug 19, 2025
  If you're experiencing incomplete or no data transmission during data communication with your Motorola Handhelds MC40, first ensure that the device hasn't been disconnected from the host computer. Reattach the Micro USB cable and try re-transmitting the data. If the issue persists, the cable configuration may be incorrect.
R
Ryan DixonAug 25, 2025
What to do if I cannot see characters on Motorola MC40 display?
- R
  Ryan PhillipsAug 26, 2025
  If you can't see characters on the display of your Motorola Handhelds MC40, make sure the device is powered on by pressing the Power button.