6
6
English
b. sliding the pager into the charger pocket, ensuring complete contact between the charger 
and pager contacts.
4. When the pager is properly seated in the pocket, the charger LED will light in accordance with 
Table 4 on page 9.
Note: 
• Charge new batteries overnight to ensure full charge. To minimize charge time, it is recommended 
to turn the pager OFF.
• The Standard Charger is not designed to accommodate the alkaline battery tray.
5. Insert a battery into the charger’s rear pocket by:
a. aligning the slot on each side of the battery with the corresponding raised rail on each side 
of the charger pocket.
b. sliding the battery into the charger pocket, ensuring complete contact between the charger 
and battery contacts.
6. When the battery is properly seated in the pocket, the charger LED will light in accordance with 
Table 4 on page 9.
Note: 
• Charge new batteries overnight to ensure full charge.
• The Standard Charger is not designed to accommodate the alkaline battery tray.
68012010009_ba.book  Page 6  Wednesday, July 19, 2017  4:57 PM