Need help?Do you have a question about the Motorola Motozine ZN5 and is the answer not in the manual?
General| Network Technology | GSM |
|---|---|
| 2G bands | GSM 850 / 900 / 1800 / 1900 |
| GPRS | Class 10 |
| EDGE | Class 10 |
| Announced | 2008, June |
| Status | Discontinued |
| SIM | Mini-SIM |
| Type | TFT, 256K colors |
| Video | Yes |
| Secondary | No |
| Alert types | Vibration; Downloadable polyphonic, MP3 ringtones |
| Loudspeaker | Yes |
| 3.5mm jack | Yes |
| WLAN | No |
| Bluetooth | 2.0, A2DP |
| Java | Yes, MIDP 2.0 |
| Battery | Removable Li-Ion 950 mAh battery |
| Colors | Black |
| Resolution | 240 x 320 pixels |
| Memory Card slot | microSD |
| Camera | 5 MP |
| USB | 2.0 |
| Radio | FM radio |
| Operating System | Proprietary |
Identifies and locates controls, indicators, and I/O ports on the ZN5 phone with reference to Figure 1.
Explains consequences of battery removal and the importance of turning off the phone first.
Details the procedure for removing the battery door and battery, including safety precautions.
Details the procedure for removing and replacing the SIM card from the phone.
Provides steps to remove the speaker cover using a tool to disengage snaps.
Guides on removing the rear housing by first unscrewing and then releasing snaps.
Guides on disengaging flex connectors for side key, camera, and flash modules.
Guides on preparing to remove the front housing by lifting the PCB and disengaging the keypad connector.
Details rotating the display to disengage hooks, avoiding touching the glass.
Details disconnecting the daughter board, removing it, and opening the display module connector.
Details inserting the display flex into the ZIF connector and closing the ZIF door.
Guides on placing the Daughter PCB onto the Main PCB, connecting BTB connectors and adhesive tape.
Details placing the display module on the PCB and ensuring hooks and dimples are correctly aligned.
Guides on attaching flex connectors to the Main PCB and placing it into the front housing.
Guides on placing the camera module and connecting its flex connector to the daughter board.
Guides on placing the flash module and connecting its flex connector to the daughter board.
Guides on connecting the Side-key Flex to the daughter board using the shield corner for alignment.
Guides on inserting the USB Grommet tether and pressing it firmly into place.
To Next Page
