5.1 - 6 MTP850 TETRA Handportable Terminal / Basic Service Manual TEST SETUP & TESTING 380–430MHz
The displayed values are factory defaults and should not be changed.
Power On Registration: required
Power Off Deregistration: required
Priority Cell: yes
Minimum Mode Service: may be used
Migration: supported
System Wide Services: normal mode
18. Press “More” soft key.
TETRA Voice Service: supported
Circuit Mode Data Service: supported
(Reserved): available
SNDCD Service: available
Air Interface Encryption: not available
Advanced Link: not supported
19. Press the “Return” soft key.
20. Press the “Neighbr Cell” soft key.
21. Verify that the following NEIGHBOUR CELL INFO values are displayed:
Note: The displayed values are factory defaults and should not be changed.
NEIGHBOUR CELL BROADCAST: not SUPPORTED
BROADCAST INTERVAL: 5s
NEIGHBOUR CELL CHANNEL: 3500
NEIGHBOUR CELL LOCATION AREA: 00017
NEIGHBOUR CELL IDENTIFIER: 01
SLOW RE-SELECT THRESHOLD: 10dB
PRESS “MORE” SOFT KEY
SLOW RE-SELECT HYSTERESIS: 10dB
To Next Page
Loading...
