Motorola MTP850 S - How to Configure the IFR 2968 Setup

TEST SETUP & TESTING 806-870MHz MTP850 TETRA Handportable Terminal / Basic Service Manual 5.2 - 5
How to Configure the IFR 2968 Setup
Perform the following steps to configure the IFR 2968 with the radio set:
1. Turn ON the IFR.
2. Press “Systems” Mode Key (wait until the digital system is initialized).
3. Press “Tetra Mobile” soft key.
4. Press “Setup” soft key and enter the System Parameters Screen.
5. Press “Channel Plan” soft key.
6. Press “More” soft key.
7. Press “Tetra 800MS” soft key. The “Control Channel” automatically changes
to “2040”; and “Traffic Channel” automatically changes to 2140.
8. Press twice the “Traffic Channel” soft key and check that the marker goes to
Timeslot. Press Data key “3” followed by the “Traffic Channel” soft key, to
change to Timeslot “3”.
9. Press “Country Code” soft key. Enter “234” and press again “Country Code”
soft key.
10. Press “Network Code” soft key. Thereafter, enter “2392” and press “Network
Code” soft key.
11. Press “Base Color” soft key. Thereafter, enter “1” and press “Base Color” soft
key.
12. Press “More” soft key.
13. Press “Location Area” soft key. Thereafter, enter “22” and press “Location
Area” soft key.
14. Press “More” soft key.
15. Press “Min Rx Level” soft key. Thereafter, enter “-110dBm” and press “Min Rx
Level” soft key.
16. Press “Max Tx Level” soft key. Thereafter, enter “30dBm” and press “Max Tx
Level” soft key.
17. Press “Access Parameter” soft key. Thereafter, enter “-53dBm” and press
“Access Parameter” soft key.
18. Press “Base Service” soft key.
Note: You are entering base services setup.