MAINTENANCE MTP850 TETRA Handportable Terminal / Basic Service Manual 6 - 13
Removing and Installing the Sim Card Door
Recommended tools: T-6 Torx bit, Torx driver.
To remove the Sim Card Door from the unit
1. Remove the battery.
2. Using the Torx driver with the T-6 Torx bit, unscrew the two screws fastening
the latch to the back housing.
3. Remove the latch from the back housing.
4. Remove the Sim card Door.
To install the Sim Card Door onto the unit
1. Place the Sim card Door into position on the back housing.
2. Place the latch onto the back housing, including two flathead screws.
3. Using the Torx driver with the T-6 Torx bit, screw the two screws fastening the
latch to the back housing.
4. Install the battery.
Figure 9 SIM Card Door Removal and Installation
To Next Page
Loading...
