MAINTENANCE MTP850 TETRA Handportable Terminal / Basic Service Manual 6 - 17
8. Install the UCM Board and the Retainer Rotary Connector. Refer to
“Removing and installing the UCM Board” on page 6-14.
9. Close the audio jack cover.
To install the Internal Assembly (for MTP850 S and MTP850 FuG
terminals)
1. Assemble the UC Flex Holder on the front housing, to shield the UC Flex
cable during assembly.
2. Position the Internal Assembly over the front housing
3. Gently push the Internal Assembly down into the front housing until three
clicks are heard indicating that the Internal Assembly is secured in place.
4. Remove the UC Flex Holder.
5. Install the accessory connector into the front housing.
6. Install the Retainer Accessory Connector.
7. Connect the accessory flex cable to the main board.
8. Connect the rotary flex cable to the main board.
9. Connect the UC flex cable to the main board.
10. Install the UCM Board and the Retainer Rotary Connector. Refer to
“Removing and installing the UCM Board” on page 6-14.
.
Figure 11 Removal and Installation of the Internal Assembly 1
To Next Page
Loading...
