http://www.motorola.com/computer/literature IN-3
I
N
D
E
X
ESD (electrostatic discharge), precautions
against 1-3
ESDI Winchester hard drive D-3
Ethernet
controller modules supported C-1
interface 4-16
station address 4-16
extended addressing 1-26
F
features, hardware 4-1
firmware 2-2
directories 3-5
documentation E-1
Flash memory 3-3, 4-11
Flash write-protect header (J24) 1-15, 4-11
flexible diskettes (controller data) D-2
floppy diskettes D-4
floppy drives (disk/tape controller) D-2, D-3
forced air cooling A-2
front panel switches and indicators 2-1
functional description 4-1
fuses 1-27
G
GCSR (global control/status registers) 1-27
general-purpose readable switch (S4) 1-17
global bus timeout 1-26
global control/status registers (GCSR) 1-27
grounding A-4
grounding strap, use of 1-3
H
handshaking, hardware 2-8
hard disk drive D-3
hardware
features 4-1
initialization 2-3
interrupts 4-18
preparation 1-1
high-temperature operation A-3
humidity, relative A-1
I
I/O interfaces 4-12
IACK (interrupt acknowledge) signal 1-24
indicators 2-1
IndustryPack (IP)
interface functions 4-15
modules, installation 1-23
signals 5-1
IndustryPack modules
base addresses of 3-19
configuration 3-20
configuring 3-19
general control register 3-20
memory size 3-20
initial conditions 2-4
installation
board 1-23
SIMs 1-11
transition modules 1-24
installation considerations 1-26
interconnect signals 5-1
interrupt acknowledge signal (IACK) 1-24
interrupt control registers 3-20
interrupt functions 4-13
Interrupt Stack Pointer (ISP) 3-4
interrupts, hardware 4-18
IOT command parameters D-5
IP (IndustryPack)
bus clock header (J14) 1-8
bus strobe select header (J19) 1-13, 2-7
controller emulations (IP1/IP2) 1-19
reset signal 4-16
IP2 interface function 4-15
IP32 CSR bit (IP bus clock) 1-8
ISP (Interrupt Stack Pointer) 3-4
J
J15 connector (SIM selection) 1-9
J16 jumpers 1-12
J17 jumpers 1-12
J18 serial connector 4-19
J19 jumper 1-13
To Next Page
Loading...
