4
English
c. When the battery is properly seated in the pocket, the RED
LED illuminates to indicate that the battery is charging
rapidly.
d. The LED will change to a steady green light to indicate that
the battery is fully charged.
5. To charge a Bluetooth
accessory:
a. Refer Table 4 for supported Bluetooth accessories.
b. Pull out the micro-USB plug.
c. Insert the plug into Bluetooth accessory.
d. See indicator light on the Bluetooth accessory for charging
status.
e. To remove a Bluetooth accessory from the charger, use
one hand to hold the micro-USB plug and the other hand to
remove the Bluetooth accessory. Pull by the plug rather
than the cord.
Figure 1: Tri-Unit Charger
For battery PMNN4425_
For battery HKNN4013_
Power receptacle
Battery divider
LED
Battery pocket
Radio pocket
Micro-USB plug
68012007042_b.book Page 4 Thursday, March 14, 2013 11:19 AM
To Next Page
Loading...
