21
English
Requesting IMPRES
Battery Calibration
• Calibration is disabled in
charger.
• Charging battery until
OK is selected or time-
out.
Warning:
ENABLE BATTERY
CALIBRATION?
• Press OK to
enable Calibration.
• Ignore for normal
charging
(message
disappears after
one minute).
Steady Red
Battery Discharging (OK
selected)
CAL DISCHARGE
Steady Amber
Rapid Charging
CAL RAPID CHARGE
xxxx0mAh yyy%
Steady Red
Charged to 90% or more
CAL TRICKLE CHRGE
xxxx0mAh yyy%
Flashing Green
Charged to 95% or more
CHARGE COMPLETE
xxxx0mAh yyy%
Battery Calibration successful:
Steady Green
Battery Calibration successful, but
may be nearing End of Service
(battery is usable):
Flashing Red/Green
Fault
Warning:
NOT CHARGEABLE
REMOVE& REINSERT
Flashing Red
Table 10: Calibrating/Reconditioning IMPRES 2 or IMPRES Batteries -
Calibration Initially Disabled, then Enabled (Cont.)
Status Charger Display LED Indicator
MN003555A01.book Page 21 Wednesday, February 14, 2018 2:40 PM
To Next Page
Loading...
