Motorola PRO5100 - Sending a Call; Receiving a Call

11
English
GETTING STARTED
Press the Home Revert button.
Method 3 (if programmed by your dealer [see
pages 4 - 5]. Enhanced keypad microphone
required.)
SENDING A CALL
If your system uses the request-to-talk feature,
use the following method to send a call:
RECEIVING A CALL
1 Press the Direct Channel Access button.
2 Enter the desired channel using the enhanced
keypad microphone.
3 Press the Direct Channel Access button
to confirm your selection.
1 Turn your radio on.
2 y or z to select the desired channel.
3 Hold the microphone vertically 1 to 2 inches
(2.5 to 5 cm) from your mouth. Press the PTT
to talk; release it to listen.
1 Turn your radio on.
2 y or z to select the desired channel.
3 Press the PTT (for priority requests to talk,
the PRTT) button and wait for the talk permit
tone.
4 Hold the microphone vertically 1 to 2 inches
(2.5 to 5 cm) from your mouth. Press the PTT
to talk; release it to listen.
1 Turn your radio on.
2 Adjust the radio’s volume, if necessary (see
page 9).
3 Select the desired channel.
4 To respond, hold the microphone vertically 1
to 2 inches (2.5 to 5 cm) from your mouth.
Press the PTT to respond to an incoming call;
release it to listen.
English.book Page 11 Wednesday, July 21, 1999 1:42 PM