Sending a Call
1. Turn radio on and select appropriate zone and channel.
2. Press PTT, hold the microphone 1 to 2 inches (2.5 to 5 cm) from your mouth,
and speak clearly into it.
3. Release PTT to listen.
Receiving a Call
1. Turn radio on and adjust volume to the desired level.
2. Select desired channel.
3. To respond to an incoming call, press PTT, hold the microphone 1 to 2 inches
(2.5 to 5 cm) from your mouth, and speak clearly into it.
Deleting a Nuisance Channel During Scanning
1. While radio is on a nuisance channel, hold down preprogrammed Scan button
until you hear a tone.
2. Release Scan button.
Making a Phone Call
1. Press Phone button, or select Phone from the menu.
2. If access code is not displayed, send access code if required.
3. Send phone number in one of the following ways:
• Press and release PTT to send last dialed number.
—
or
—
• when using enhanced keypad microphone only, press preprogrammed
Speed Dial button, followed by a keypad key (1–8), to access first nine num-
bers in your phone list. (Press PTT if buffered dial.)
—
or
—
• when using enhanced keypad microphone only, enter phone number using
the keypad. (Press PTT if buffered dial.)
4. Press PTT, hold the microphone 1 to 2 inches (2.5 to 5 cm) from your mouth,
and speak clearly into it.
Ending a Phone Call
1. Send deaccess code if required.
2. Press preprogrammed Phone button, or press the Exit key.
Sending and Cancelling an Emergency Alert
• To activate
Emergency Alert
, press preprogrammed Emergency button or
footswitch.
• To cancel, press and hold down Emergency button
.
CDM1250
™
Quick Reference Card
Record the functions for your radio’s programmable buttons in the table
provided below. For further information, see page 4 of this User Guide.
To Next Page
Loading...
