27
calls
Note:
If you do not enter a MOTOtalk name,
“MOTOtalk” is displayed.
3
Press
-
under
Done
.
change Talkgroup within a set
1
In the network screen turn the Talkgroup
knob until you reach the desired talkgroup.
2
Wait for timeout. The idle network screen
appears.
Note:
The set to which the Talkgroup belongs
is called the active set.
enter and exit MOTOtalk
1
In the network screen turn the Talkgroup
knob until it reaches the required
MOTOtalk channel.
2
Wait for timeout.
Switching to MOTOtalk Please
Wait
displays. After a few seconds, the
MOTOtalk idle screen appears.
Note:
The MOTOtalk idle screen layout and
functionality differ from those of MOTOtalk
accessed via the main menu.
3
To exit MOTOtalk, turn the Talkgroup knob
until it reaches the required Talkgroup.
or
In the idle screen press
{
, and
-
under
Yes
.
4
Wait for timeout.
Switching to Network Please
Wait
displays. After a few seconds, the
network idle screen appears
.
Set as MOTOtalk:
Assign the knob position to
the MOTOtalk name, code, and channel. A
channel is a number between 1 and 10. A
code is a number between 1 and 15.
Note:
Private Only and Receive All codes
are not supported.
option
To Next Page
Loading...
