GETTING STARTED
English
30
RADIO CLONING
The RDM Series MURS Two-Way radio
profiles from one radio (the “Source” radio) to a
second radio (the “Target” radio) by using any
one of these 3 methods:
• One Multi Unit Charger (optional accessory)
• Two Single Unit Chargers and a Radio-to-
Radio cloning cable (optional accessory)
• the CPS (free software download)
Cloning with a Multi-Unit Charger (MUC)
The Source radio has to be in Pocket 1, 3 or 5
while the Source radio to be cloned has to be in
Pockets 2, 4 or 6, matching in the MUCs
pockets by pairs as follows: 1 and 2 or 3 and 4
or 5 and 6.
When cloning, the MUC does not need to be
plugged into a power source, but ALL radios
require charged batteries.
To clone radios with the MUC:
1. Turn ON the Target radio and place it into one
of the MUC Target Pockets
2. Power the Source radio following the sequence
below:
Long press the PTT button and SB2
simultaneously while turning the radio ON.
Wait for 3 seconds before releasing the buttons
until a distinctive audible tone is heard.
To Next Page
Loading...
