BASIC
CONFIGURATION
English
37
set to OFF and the default sensitivity value for
iVOX is set to Medium.
To configure VOX/iVOX sensitivity:
1. Short press the MENU button and navigate until
the following screens are displayed:
If iVOX is enabled the radio will display the
following:
If VOX is enabled (with accessory connected)
the radio will display the following:
2. To change the sensitivity level, use the /
buttons and choose from the following
options:
0 = OFF (For VOX accessories only)
1 = Low sensitivity
2 = Medium sensitivity
3 = High sensitivity
3. Long press the PTT button to save and exit,
--or-- short press the PTT button to configure
the next feature without saving.
NUISANCE CHANNEL DELETE
This feature temporarily removes channels
from the “Scan List” to disregard irrelevant
conversations on a “nuisance” channel that tie
up the radio’s scanning.
To delete a channel from the scan list:
1. Short press the SB2 button to enable “Scan
Mode.” This feature is pre configured by default.
2. Wait until the radio stops on the “nuisance”
channel.
3. Long press the SB2 button. The nuisance
channel is temporarily deleted during the
scanning session.
IVOX
VOX
To Next Page
Loading...
