ADVANCED
CONFIGURATION
English
49
7. Long press the PTT button to save changes and
return to “Idle” Advanced Configuration Mode.
Once in “Idle” Advanced Configuration Mode,
LED indicator will start blinking a green
heartbeat.
8. Long press the PTT button to exit Advanced
Configuration Mode.
Configuring Auto-Scan
Auto-Scan is the last Advanced Configuration
Mode and can be set to “ON” or “OFF” on a
particular channel.
To set Auto-Scan to “ON”:
1. Enter Advanced Configuration Mode and select
the desired channel.
2. Short press the PTT button six times to enter
Auto-Scan Programming Selection Mode. The
radio will signal beeps and will show the current
Auto-Scan setting (refer to “Reading Auto-Scan
Values” on page 47).
3. Short press the SB1 button to toggle ON/OFF
the Auto-Scan feature in the channel. When ON
radio LED will blink RED once. When OFF radio
LED will blink ORANGE once.
To Next Page
Loading...
