5.4.3
Troubleshooting Cloning Mode
When and where to use:
If the voice announcement from your radio indicates that the cloning process has failed, perform the following
actions before attempting to restart the cloning process.
Procedure:
1. Ensure that the batteries on both radios are fully charged and engaged properly on the radio.
2. Check the cloning cable connection on both Single-Unit Chargers (SUC).
3. Ensure that the battery is engaged properly on the radio.
4. Ensure that there is no debris in the charging tray or on the radio contacts.
5. Ensure that the target radio is turned on.
6. Ensure that the source radio is in cloning mode.
7. Ensure that the two radios are both from the same frequency band, region, and transmission power.
NOTE:
The cloning cable is designed to operate only with compatible Motorola Solutions SUC
(RLN6175 and PMLN6394).
When ordering a cloning cable kit, refer to part number HKKN4028_.
For more information about the accessories, see Authorized Accessories List on page 43.
68012009071-BD
Chapter 5: Radio Programming through CPS
35
To Next Page
Loading...
Need help?
General
