PROGRAMMING
FEATURES
English
42
Programming Mode FAQ
1.
I got distracted while programming and
forgot which feature I was
programming. What should I do?
Return to 'Idle' Programming Mode and start
over.
• Long press the PTT button. The radio will return
to the 'Idle' Programming Mode or,
• Turn OFF the radio and enter Programming
Mode again (see instructions in the beginning of
this section)
2.
I am trying to program a frequency (or
code) value but the radio would not do it.
It rolled over and took me back to value
‘0’.
The radio will not allow you to program any
values that are not available in the frequencies
and codes pool. For example, if you try to
program code 220, the radio would not accept
it, as the maximum value allowed is 219. Same
thing will happen with frequencies. Check the
Frequencies and Codes Charts section to make
sure you are programming a valid number.
3.
I am trying to enter the Programming
Mode but the radio would not do it.
The radio might be locked using the CPS to not
allow Front Panel Programming. To re-enable,
use the CPS.
To Next Page
Loading...
Need help?
General
