English
41
PROGRAMMING FEATURES
Tones’ selection by short pressing the PTT
button or
(Menu) button.
The radio display shows the Programming Call
Tone’ as follows:
The radio display blinks the current call tone
setting. You can select the desired call tone
value (0,1,2 or 3) by pressing the and
buttons. Each time you select a different value,
your radio sounds the selected call tone
(except for value ‘0’).
Once you have selected the desired call tone,
long press the PTT button to exit and save, or
short press the PTT button to move to the next
programming feature without saving.
Note: The values available for Call Tones settings
are dependent on the values programmed
via the CPS. Call Tones is disabled when
the value is set to ‘0’.
PROGRAMMING MICROPHONE GAIN
LEVEL
To configure the Microphone Gain Level, enter
the Advanced Configuration Mode and scroll
up or down through the programming modes
by short pressing the PTT button or
(Menu) button until you reach the ‘Microphone
Gain Level Programming Mode’.
The radio display shows the Microphone Gain
Level as follows:
The radio display blinks the current Microphone
Gain Level setting. You can select the desired
Microphone Gain Level (1 = low gain, 2 =
To Next Page
Loading...
Need help?
General
