22 Handset settings
5.4 Handset name
If you are using more than one handset with your S12 base, you can set a personalized
name for each handset to easily distinguish between them.
A name can be up to 10 characters long.
1. Press
m, scroll d to
HANDSET
and press m.
2. Scroll
d to
NAME
and press m.
3. Enter the new handset name and press
m to conrm. Delete the current name by
pressing
B
.
NOTE
The handset name will only be displayed for approximately 20 seconds when no button is
pressed. If you make a mistake, press
B
to delete the last character or digit.
See “ENTERING NAMES” and “WRITING TIPS” on page 19.
5.5 Language
1. Press m, scroll d to
HANDSET
and press m.
2. Scroll
d to
LANGUAGE
and press m.
3. Press
u or d to select your preferred language and press m to conrm.
5.6 Key beep
When you press a button on the handset keypad, you will hear a beep. You can switch
these beeps on or o.
1. Press
m, scroll d to
HANDSET
and press m. The display shows
BEEP
.
2. Press
m to select. The display shows
KEYTONE
.
3. Press
m to select.
4. Press
u or d to select
ON
or
OFF
and press m to conrm.
5.7 Battery low warning beep
When the battery is almost fully discharged, you will hear a warning beep every minute
during a call. You can switch these beeps on or o.
1. Press
m, scroll d to
HANDSET
and press m. The display shows
BEEP
.
2. Press
m to select.
3. Scroll
d to
LOW BATTERY
and press m.
4. Press
u or d to select
ON
or
OFF
and press m to conrm.
To Next Page
Loading...
Need help?
General
