24 Base settings
6. Base settings
6.1 Base ringer volume
Choose from 5 volume levels or O.
1. Press
m, scroll d to
SETUP
and press m. The display shows
BASE VOLUME
.
2. Press
m.
3. Press
u or d to select the volume (1 - 5 or
OFF
).
4. Press
m to conrm or B to return to the previous menu.
6.2 Base ringer melody
Choose from 5 dierent base ringer melodies.
You will hear a sample ring as you scroll to each ringer melody.
1. Press
m, scroll d to
SETUP
and press m.
2. Scroll
d to
BASE MELODY
and press m.
3. Press
u or d to select the ringer melody (1 - 5).
4. Press
m to conrm or B to return to the previous menu.
6.3 Change base PIN code
Some functions are protected by a 4 digit PIN code which must be entered if you want to
change the settings. The default PIN is 0000. You can change this to your own preferred
number.
When you enter a PIN, the digits are shown as ****.
1. Press
m, scroll d to
SETUP
and press m.
2. Scroll
d to
PIN CODE
and press m.
3. Enter the 4 digit PIN code (default = 0000) and press
m.
4. Enter the new PIN and press
m to conrm.
5. The display shows
RETYPE
. Re-enter the new PIN and press m to conrm.
IMPORTANT
If you change the PIN code, please keep a record of the new number.
6.4 Dial mode
Your S12 is set to tone dialling. You should only need to change this if connected to an
older type of switchboard / PBX which requires pulse dialling.
1. Press
m, scroll d to
SETUP
and press m.
2. Scroll
d to
DIAL MODE
and press m.
3. Press
u or d to select
TONE DIAL
or
PULSE DIAL
and press m to conrm.
To Next Page
Loading...
Need help?
General
