Motorola Talkabout T5300 - Channel; Interference Eliminator Code (T5400 Only)

15
Talking and Listening
Channel
• With radio On, press
\, Current Channel will begin to flash.
• Use
[ and ] to change Channel while flashing.
• Press
M
to set new Channel.
Interference Eliminator Code (T5400 Only)
The interference eliminator codes help minimize interference by
providing you with a choice of code combinations.
• To set the code, press
\ until the code display begins to blink.
• Then press
[
or
]
to set the code.
• Press
M
to save the code setting.
You must set the Interference Eliminator Code to 0 on a T5400 to communicate with
a T5300.
You can specify a different code for each channel. To set a channel and code
combination, press
\
and then press
[
or
]
to select the channel. Press
\
again and then press
[
or
]
to select a code. Press
M
to exit the menu and to
save the channel and code combination. To set another channel and code
combination, repeat these steps.
Volume
• Rotate
P while holding down Q until you reach a comfortable listening level.
• Rotate
P clockwise to increase and counter-clockwise to decrease volume.
6864110r09o.book Page 15 Friday, December 21, 2001 12:04 PM