17
Alerts
Call Tone
The Call Tone obtains others’ attention before you start talking. Press
^ and users
using the same Channel and Code (T5400 only) will hear your Call Tone. T5400 has
5 Call Tones, T5300 has 1 Call Tone. Setting the Call Tone to
0 disables ^.
• With the radio On:
for T5400, press
\ 3 times and current Call Tone setting 0-5, will begin to flash.
E will appear in the upper portion of the display.
for T5300, press
\ 2 times and you can scroll between 0 and 1.
• Use
[ and ] to change and hear Call Tone while flashing.
• Press
\ or
M
to set new Call Tone.
Roger Beep/Talk Confirmation Tone
When you turn on this feature, your two-way radio transmits a unique tone when you
finish transmitting. It’s like saying “Roger” or “Over” and lets others know you’re
finished talking.
• To enable Roger Beep/Talk Confirmation Tone, press and hold
] as you turn
your radio On. Now, when you release
M
, your set tone lets your friends know
you’re finished talking and
!will be on the display.
• To disable the Talk Confirmation Tone feature, turn your radio Off and then back
On while pressing and holding
]. ! will not appear.
6864110r09o.book Page 17 Friday, December 21, 2001 12:04 PM
To Next Page
Loading...
