Talking and Listening
29
Setting the Interference Eliminator Code
You can specify a different code for each channel. To set a channel and code
combination, press
\
and then press
[
or
]
to select the channel. Press
\
again and then press
[
or
]
to select a code. Press
M
to exit the menu and to
save the channel and code combination. To set another channel and code
combination, repeat these steps.
Volume
To set the code, press \ twice until the code number display begins
to blink. Then press
[
or
]
to set the code. Press
M
to save the
code setting. To hear everyone on your channel, select code
0
.
You can set the volume whenever you are not using a menu. Press
[
or
]
until it’s just right. The display will show
and the volume
setting (
1
to
20
)
with
1
being
the lowest volume and
being the
highest volume.
Caution:
Do not hold the radio too close to your ear when the volume is at a high
setting. This could cause hearing damage.
5
1 T6200.book Page 29 Tuesday, March 20, 2001 10:41 AM
To Next Page
Loading...
