24
English
Attaching the Antenna
Insert the bottom of the antenna into the screw-in base on the top of
the CEP400. Turn clockwise until snug. Do not force.
Powering On/Off (On-Off/End/Home Key)
To power On, press and hold . Your CEP400 performs a self-
check and registration routine. After successful registration, the
CEP400 is in service.
To power Off, press and hold . You will hear a beep and the
Powering Off message is displayed.
Powering On (Emergency Button)
Press and hold the Emergency button to power On. The CEP400
will power On in Emergency Mode or in standard mode
(as programmed).
Powering On with Transmit Inhibit (TXI) Active
Transmit Inhibit is a feature allowing you to switch off transmission
before entering a Radio Frequency (RF) sensitive area. To activate
this feature, press and select More... > Networks
> TXI Mode > Activate.
Turn the CEP400 Off before installing or removing the antenna.
Pressing the Emergency button, even if
Transmit Inhibit is activated, causes the
CEP400 to transmit immediately. The CEP400
must NOT be within the RF sensitive area when
entering Emergency Mode.
To Next Page
Loading...
