2.4 Registration (Pairing)
The Baby Monitor is pre-registered to your Parent Unit. You do not
need to register it again unless the Baby Unit loses its link with the Parent
Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedures below:
1. Press the
menu button and the menu bar will pop up.
2.
Pre
s
s
the < LEFT button or > RIGHT button until is highlighted,
and the
del/ add/ view/ scan menu will
pop up.
3.
Press the + UP button or - DOWN button to select add, and press
the
OK button to confirm.
4.
Camera / / / will pop up. Press the + UP
button or
-
DOWN button to select the desired Camera, and press the OK
button to start searching for a camera unit.
Note: If a camera is currently paired with the Parent Unit, its camera
location (with a * against it) cannot be selected for a new registration.
5. Press and hold
the PAIR button on the back of the Baby Unit until the
Paren
t Unit finds the camera, beeps and PAIR OK appears on the
screen. The video from the camera will then appear.
NOTE
A ca
mera can only be registered to one Parent Unit at any one time.
To Next Page
Loading...
