3. Using the Baby Monitor
3.1 Setting Up
Place the Baby Unit in a convenient location (e.g. on a table) and point the
camera lens towards the area you want to monitor.
Adjust the angle of the Baby Unit's camera until you are satisfied with the image
shown on the Parent Unit.
NOTE
Do not place the Baby Unit within the baby's reach! If there is inter- ference with
the picture or sound, try moving the units to different locations, and ensure they are
not close to other electrical equipment.
3.2 Night Vision Mode
The Baby Unit has 8 high-intensity infrared LEDs for picking up clear images in the
dark. When the built-in photo sensor on the top of the Unit detects a low level of
ambient light, the LEDs will automatically activate and the screen on the Parent
Unit will display in black and
white. The icon will be displayed at the top of the screen.
3.3 Talk Mode
Press and hold the TALK button on the Parent Unit to talk to your baby
through the Baby Unit’s loudspeaker.
The icon will be displayed at the top of the LCD screen.
3.4 Video ON/OFF
Press
VIDEO On/Off button to turn the LCD screen on or off, whilst still
leaving the audio monitor on.
3.5 Temperature Display (HH °C / °F or LL °C / °F)
The temperature reading from the temperature sensor at the back of the Baby
Unit will be displayed at the top of the LCD screen. The readings will turn RED if the
temperature goes above 29°C / 84°F or below 14°C / 57°F. The reading will change
to HH °C / °F if the temperature goes above 36°C / 97°F. The reading will change to
LL °C / °F if the temperature goes below 1°C / 34°F.
To Next Page
Loading...
