Advanced Features
English
23
Remote Monitor
Use the Remote Monitor feature to turn on the microphone of a
target radio (subscriber alias or IDs only). No audible or visual
indication is given to the target radio. You can use this feature to
monitor, remotely, any audible activity surrounding the target
radio.
Your radio must be programmed to allow you to use this feature.
Initiating Remote Monitor
Procedure:
Using the programmed Remote Monitor button.
1 Press the programmed Remote Monitor button.
2 Por Q to the required subscriber alias or ID and press
N to select.
3 Radio sounds an alert tone and the LED blinks green.
4 Wait for acknowledgment.
5 The display shows Remote Monitor Successful.
OR
The display shows Remote Monitor Failed.
6 If successful:
The radio starts receiving audio from the monitored radio for
a programmed duration.
Once the timer expires, the radio sounds an alert tone and
the LED turns off. The display shows Remote Monitor
Ended.
OR
If unsuccessful:
The radio repeats the attempt until the programmed number
of tries expires.
OR
Procedure:
Using the menu.
1 S to access the menu.
2 Por Q to Contacts and press N to select.
3 Por Q to the required subscriber alias or ID and press
N to select.
OR
Por Q to Manual Dial and press N to select.
If there was previously dialed ID, the ID appears along with
a blinking cursor. Use the keypad to edit the ID. Press
N to
select.
OR
Por Q to Manual Dial and press N to select. Key in
the subscriber alias or ID and press N to select.
NAG-LACR-EMEA.book Page 23 Monday, April 28, 2008 4:59 PM
To Next Page
Loading...
Need help?
General
