MOTUL BIOCLEAN - Maintenance

14
Operating Instructions Motul BioClean Parts Washer – English
Maximum 100L
Minimum 60L
Maintenance position
(table)
The running time of the
liquid pump can be adjusted
between 5 and 60 minutes by
turning the setting wheel.
The temperature
can be adjusted
between 20 and 45 °C
by turning the setting
wheel.
7. Maintenance
Warning! Before beginning to work on ixtures, make sure that there is no electrical
current. Pull the plug from the mains! Check that the unit has no current!
For maintenance purposes the table can be opened sideways.
The sink will be kept into open position via sink rod, make sure
the sink is lifted up to end postion.
Aeration
The build-in aeration feature is vital to the performance of the
bioremidiation process. Therefore check weekly the air input,
air bubbles should be visible at the surface of the liquid. If
necessary clean or change the air sprinkler.
Fill Level
Monitor the ill level regularly by means of the markings on the wall of the container,
because of liquid losses due to evaporation and manual take out. If the ill-up height falls
below the minimum level, heating and pump will be switched o automatically for safety
reasons, this will be indicated by lashing red LED. Fill up with cleaning luid so that the
optimal illing quantity is reached and the maximum mark is not exceeded. Ensure that
loat switch loats freely in the liquid.
Setting the temperature and the pump running time
For the setting disconnect the device from the power supply and set the desired value.