The spray arm can be easily
the nozzles to prevent possible
clogging.
To remove the spray arm, hold and pull it out.
Wash the spray arm under running water and
attach it back in place, checking that the rotary
movement is in no way impeded.
Frost Precautions
Avoid placing the dishwasher in a location where
the temperature is below 0°C. If this is unavoidable,
empty the dishwasher, close the door, disconnect
the water inlet pipe and empty it.
TROUBLESHOOTING
Possible Causes Solutions
Dishwasher
will not start.
Fuse blown, or the
circuit breaker
tripped
Replace fuse or reset circuit breaker.
Remove any other appliance sharing the
same circuit with the dishwasher.
Power supply is not
turned on.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
The door has not
been properly
closed.
Close the door securely.
Water not
pumped from
dishwasher
Kink in drain hose Check drain hose.
Filter clogged Check the filters (see “Cleaning the
Filters”).
Kitchen sink clogged
Check kitchen sink to make sure it is
draining well. If kitchen sink is not
draining, you may ask a plumber to
check it.
Cleaning the Spray Arm
removed for periodic
cleaning of
To Next Page
Loading...