mountztorque.com - 1080 N 11
th
St, San Jose CA 95112 - 408.292.2214
-
Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat, or
hearing protection must be used for appropriate conditions.
Tool use and Care
-
Use clamps or other practical way to secure and support the workplace to a stable platform.
Holding the work by hand or against your body is unstable and may lead to loss of control.
-
Do not force tool. Use the correct tool for your application. The correct tool will do the job better
and safer at the rate for which it is designed.
-
Do not use tool if switch does not turn it on or off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
-
Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing the tool. Such preventive safety
-
Store idle tools out of reach of children and other untrained persons. Tools are dangerous
in the hands of untrained users.
-
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools, with
sharp cutting edges are less likely to bind and are easier to control.
-
Check for misalignment or binding of moving parts, breakage of parts, and any other condition
that may affect the tools operation. If damaged, have the tool serviced before using. Many
accidents are caused by poorly maintained tools.
-
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool, may become hazardous when used on another tool.
SERVICE
-
Tool service must be performed only by qualified personnel. Service or maintenance performed
by unqualified personnel could result in a risk of injury
-
When servicing a tool, use only identical replacement parts. Follow instructions in the
Maintenance section of this manual. Use of unauthorized parts or failure to follow
Maintenance instructions may create a risk of electric shock or injury.
SPECIFIC SAFETY RULES
Hold tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock the operator.
Never lubricate aerosol oil on to the electrical part.
To Next Page
Loading...