2 General information
Safety
The equipment is only designed and may only be used for the dosing of dry additives.
Any use that is not in conformity with the instructions is considered improper and as such frees the
manufacturer from any liability regarding damage to things and/or persons.
Before switching on the unit for the first time, ensure that the mains power voltage
applied is between 95 and 250VAC.
Ensure that all parts are securely fixed to the extruder, injection molding machine or machine
support.
Always switch off the Movacolor control cabinet and disconnect the mains power plug from electrical
power before performing maintenance.
Dangerous voltages are present inside the control cabinet for up to 2 minutes after it has been
switched off.
Always disconnect the main compressed air connection before performing maintenance.
Certification
The Movacolor dosing unit is designed and produced in conformity with the following European regulations:
1. standards for machinery (health, safety, environment).
2. EMC (electromagnetic compatibility).
3. 2006/42/EG.
4. RoHS.
Operating environmental conditions
1. The unit must be protected against weather conditions.
2. Operating temperature -20 to +70 degrees Celsius.
3. Protection class: IP-50.
To Next Page
Loading...