CAN bus connection
The MCTC and MCBC units communicate using a CAN BUS connection. When you order a multicomponent
system at Movacolor it will be delivered pre-wired with the correct cabling. In case you need to make
adjustments in the cabling, be aware to connect the CAN bus correctly.
There can only be one MCTC touchscreen connected to the cable loop.
Always use Movacolor selected CAN bus cable, use of wrong cabling can result in a defective system.
Alarm/warning output
In a multicomponent configuration, all alarms are centralized to the first unit (MCTC UNIT 1). In case of an
alarm on a blind controller unit X, the alarm output of unit 1 and the alarm output of unit X are activated.
To Next Page
Loading...