1.Short click SET button : When it standby, it will clear the error, alarm display, and return to normal
display.
2.Short click CODE button :
. ( In the Setting Status) Exit the current operation and return to the standby interface.
. When it standby, press the code, A dot will be indicated in the corner, now entering the code
leaning mode.
Now rst click the button on the hand transmitter you want to use, the dot may disappear ,then
press again the same button on the hand transmitter, the dot will ash, here, the code learning is
nished.
3. Short press UP button : The door will open.
4. Short press DOWN button : The door will close.
(When the door is opening or closing, it will stop if you press any key.)
5. Long press SET button : Enter function setting interface.
6. Long press CODE button : Press and hold CODE button until a
C is indicated on the display. All stored
remotes will be deleted.
7. Long press UP button : Increase the resilience. (Keep press DOWN button, after 4 seconds, it will
scroll to display
0-1-2, choose the number you want. 1=increase 25% 2=increase 50%)
8. Long press DOWN button : Restore Factory Settings
Keep press DOWN button, after 4 seconds, it will scroll to display , then the garage
door opener will restart.
Restart means all settings are back to factory settings, all learning things need to be done again
except the transmitter code learning.
PROGRAMMING INSTRUCTIONS
-9D-
Pre- Instruction for programme buttons
To Next Page
Loading...