Moxa Technologies MGate MB3180 Quick Installation Guide

- 4 -
LED Indicators—Three LED indicators are located on the top panel:
Name
Color
Function
Ready
Red
Steady on:
Power is on and the unit is booting up
Blinking:
IP conflict exists, or DHCP or BOOTP
server is not responding properly
Green Steady on: Power is on and the unit is functioning
normally
Blinking:
Unit has been found by the Location
command in MGate Manager
Off
Power is off or power error condition exists
Ethernet
Orange
10 Mbps Ethernet connection
Green
100 Mbps Ethernet connection
Off
Ethernet cable is disconnected or has a short
P1
Orange
Unit is receiving data from device.
Green
Unit is transmitting data to device.
Off
No data is being exchanged with device.
Hardware Installation Procedure
STEP 1:
After unpacking the MGate MB3180, connect the power
adaptor
.
STEP 2:
Use a standard straight-through Ethernet cable to connect the
MGate
MB3180 to a network hub or switch. Use a cross-over
Ethernet cable if you are connecting the gateway directly to a
PC
.
STEP 3:
Connect your device to the MGate MB3180
’s serial port.
STEP 4:
Place or mount the MGate MB3180. The unit may be placed
on a horizonta
l serface such as a desktop, mounted on a DIN
-
rail, or mounted on the wall.
Wall Mounting
DIN-rail Mounting

Moxa Technologies MGate MB3180 Specifications

General

Full duplex	Yes
Data transfer rate	0.1 Gbit/s
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Operating relative humidity (H-H)	5 - 95 %
Interface	RS-232/422/485, RJ45
Safety	UL 60950-1, EN 60950-1
Certification	EN 55024, \\r EN 61000-4-2 (ESD) Level 2, \\r EN 61000-4-3 (RS) Level 2, \\r EN 61000-4-4 (EFT) Level 2, \\r EN 61000-4-5 (Surge) Level 2, \\r EN 61000-4-6 (CS) Level 2, \\r EN 61000-4-8, \\r EN 61000-4-11, \\r EN 61000-4-12
LED indicators	Power
Compatible operating systems	Windows 98/ME/NT/2000, Windows XP/2003/Vista/2008/7 x86/x64

Weight and Dimensions

Weight	340 g