EasyManuals Logo

Moxa Technologies NPort 5000AI-M12 Series User Manual

Moxa Technologies NPort 5000AI-M12 Series
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
NPort 5000 Series User Manual
98
PPPD Mode
PPPD (PPP on demand) is used for dial-in services, since it provides PPP services only when receiving a
request from a remote PC.
Destination IP address: This is the IP address of the remote dial-in/ dial-out server.
Source IP address: The Source IP address is IP address assigned to this serial port.
IP netmask: The IP netmask defines the netmask, also known as the subnet mask, for the PPP connection
TCP/IP compression (default=Disable): The setting of this field depends on whether the remote user’s
application requests compression.
Inactivity time (default=0 ms): This field specifies the idle time setting for auto-disconnection. A setting of
0 ms will cause the port to remain connected even if idle.
Link quality report (default=Disable): Setting this field to Enable allows the NPort 5000 to disconnect a
connection if the link noise exceeds a certain threshold.
Username: This is the dial-out user ID account.
Password: This is the dial-out user password.
Authentication type (default=None): This field allows you to configure the method used, if any, to verify
a user’s ID and authorization.
Option
Description
Local
Verify the ID against the NPort 5000 User Table.
RADIUS
Verify the ID against the external RADIUS server.
RADIUS-Local
Radius authentication is tried first, switching to Local if unsuccessful.
Local-RADIUS
Authentication is performed locally first, switching to Radius if unsuccessful
TACACS+
Verify the ID against the external TACACS+ server.
TACACS+-Local
TACACS+ authentication is tried first, switching to Local if unsuccessful.
Local-TACACS+
Authentication is performed locally first, switching to Radius if unsuccessful
None
Authentication is not required.
Try next type on authentication denied (default=Disable): The field enables or disables the system to
try next type on first authentication denied.
Disconnect by (default=None): If this field is set as DCD-off, the connection will be disconnected when
the DCD signal is off. If this field is set as DSR-off, the connection will be disconnected when the DSR
signal is off.

Table of Contents

Other manuals for Moxa Technologies NPort 5000AI-M12 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Moxa Technologies NPort 5000AI-M12 Series and is the answer not in the manual?

Moxa Technologies NPort 5000AI-M12 Series Specifications

General IconGeneral
BrandMoxa Technologies
ModelNPort 5000AI-M12 Series
CategoryServer
LanguageEnglish

Related product manuals