In addition to placing the
NPort 5100
on a desktop or
other horizonta
you may also make use of
the DIN
options, as illustrated here.
The operating temperature of the power adapter in the box is
from 0 to 40°C. If your application is out of this range, please
use
a power adapter supplied by UL Listed External Power
Supply (The power output meets SELV and LPS and rated 12
48 VDC, minimum current 0.73 A). Moxa has power adapters
with wide temperature range (
-40 to 75°C, -40 to 167°F), the
PWR-12150-(plug type)-SA-T series, for your reference.
For the NPort’s configuration, the default IP address of the NPort is:
LAN: Static IP = 192.168.127.254; netmask = 255.255.255.0
You may log in with the password moxa to change any setting to meet
your network topology (e.g., IP address) or serial device (e.g., serial
parameters). If you would like to apply the Real COM mode to your
application, you will need to install the NPort’s driver on your desktop.
You may also refer to Moxa’s support website
https://www.moxa.com/support/
for the user’s manual, driver, NPort
Search Utility, and more.
For the NPort with DB Male serial ports, you may refer to the
DB9 Male Ports
Pin Assignment section to loop back pin 2 and
-232 interface to carry out a self test on the
Pin Assignments
Ethernet Port Pinouts
To Next Page
Loading...
