Moxi SelectAir - Section 6 Manual Setup; Comfort Level Calibration and Bed Frame Clearance; Bed Frame Side Rails

Section 6 Manual Setup
Comfort Level Reference Chart
Note: These charts are only a guideline because weight distribution varies
from patient to patient.
9. Follow facility protocol, applicable laws and regulations, and individual user safety
considerations for usage of bed frame side rails.
7. Check to ensure that the patient has immersed into the mattress about 40 – 50%. If
they have not, adjust the Comfort Level using the Comfort Level “Softer” and “Firmer”
buttons and repeat steps 6 and 7 until the proper results are achieved.
8. Once the desired setting is found, check to see if there is adequate clearance
between the patient and the bed frame b
y placing your hand between the patient and
the bed frame. There should be 3-4 inches (7-10 cm) of clearance, and the patient
should not be touching the bed frame at any point. Adjust the Comfort Level setting
until the proper results are achieved.
{
75 34 3.5-4
100 45 4
125 57 4-5
150 68 5
175 79 5-6
200 91 6-7
250 113 7-8
300 146 8-9
350 159 9
400 181 10
(Kilograms)
Setting
(Comfort Level)
Patient Weight
(Pounds)
SelectAir
SelectAir Max
Weight Ranges
100 45 1
150 68 2
200 91 3
250 113 4
300 146 5
{
(Kilograms)
Setting
(Comfort Level)
Patient Weight
(Pounds)
HybridSelect
Weight Ranges
{
300 146 6
350 159 7
400 181 8
450 204 9
500 227 10
550 249 11
600 272 12
650 295 13
680 308 13.5
BariSelect
Weight Ranges
(Kilograms)
Setting
(Comfort Level)
Patient Weight
(Pounds)
13