Moza SLYPOD PRO - Firmware Upgrade; Calibration

16
Firmware Upgrade
Updating the firmware of SLYPOD PRO should be done in the charging state. When in
charging state, turn on the device, connect the SLYPOD PRO to the App, enter the
operation interface and start the firmware upgrade. The SLYPOD PRO must be restarted
after the firmware upgrade succeeds. If the upgrade fails, the process needs to be
repeated until the upgrade succeeds.
Color Definition
Charging
Solid red
Charging completed
Solid blue
Power on
Solid green
Low voltage alarm
Red Light and Green Light on (Solid Orange)
Low voltage alarm
Red light flashing + automatic homing stop (press
the start button, red light flashing, no start)
Charging
Lift the rubber dust cover from the charging port to access a Type-C port. The SLYPOD
PRO can be charged by mobile phone charger, mobile power bank, etc. It will
automatically stop charging when the battery is full. Please disconnect the charger when
the SLYPOD PRO is full. It is recommended to use the original charging cable provided.
Calibration
Calibration is needed when there is abnormality with the movement. There are two
ways to calibrate the SLYPOD PRO: Click all three buttons (power, +, -) at the same time
or enter the operation interface to start calibration in the App. Subscribe Gudsen MOZA
official YouTube channel for the latest tutorials.