MOZELT CoolGen 4 - Page 3

MOZELT GmbH & Co. KG
Load liing magnet devices
Technical manual: CoolGen 4
Copyright: MOZELT GmbH & Co. KG, D-47269 Duisburg Edition: August 2014 Rev.: 00
Page 3
English
5. Electrical Connection
When working on energized power generators, the
applicable naonal accident prevenon regulaons shall
be observed.
The electrical installaon is to be carried out in
accordance with the relevant regulaons (e.g. line cross
secons, provision of safety arrangements). Further
instrucons are given in the documentaon.
The manufacturer of the system is responsible for
adherence to the EMC legislature. Instrucons for
installaon in accordance with the EMC Direcve are
given in the documentaon of the power generators.
6. Operation
Installaons into which the generators are built must be
equipped, if necessary, with addional monitoring and
protecon devices.
The manufacturer’s documentaon is to be observed.
Aer separang the generators from the drive unit, live
components and line connecons must not be touched
when the generator spindle is running, due to the
voltage.
All covers are to be kept closed during operaon.
In the electronics, there are intermediate
circuit capacitors.
Their discharge may take longer than 10
minutes!
Before start of work, verify isolaon from
power supply!
If this is not observed, serious personal
injuries with fatal result, severe injuries
to health or considerable damage to
property cannot be ruled out!
WARNING
7. Applicable Documents
A prerequisite for the use of a power
generator is that these operang
instrucons have been read and
understood. In parcular, the safety
notes contained there are to be
observed.
If these notes are not observed,
serious personal injuries with fatal
result, severe injuries to health or
considerable damage to property
cannot be ruled out!
WARNING