MPI KWH124 - Hot Water Temperature Adjustment

Adjustment of Hot Water Temperatures
a. Thermostat has been set at factory to about 104T. (LOW)
b. Slide "Hot Water Temperature Adjuster" knob up toward
"High" to raise water temperature.
Slide knob down toward "Low" to reduce the temperature.
c. When adjusting hot water temperature with hot-cold water
mixing valve, control the amount of cold water from main
without changing the amount of hot water being supplied.
>£Knob at position "High" provides hot water at a temper-
ature around 167T.
Knob at position "MED" provides hot water at a tempe-
rature around 130'F.
Knob at position "Low provides hot water at a temper-
ature around 104'F.
WARNING
•KHiimiaa
HIGH r
LOW
MED.
^ High temperature setting increases the risk of SCALD injury.
^Households with small children or invalids may require a 120'F or lower thermostat setting
(to prevent accidental contact with "HOT" water.)
NOTE
^Seasonal change in temperature of water from main results in different hot water
temperatures supplied. Use hot water supply tap to control hot water temperature, or
readjust thermostat setting.
7