13
GB
OVAL BRUSH
Intended for removing dust from shelves, books, lamp shades, frames, decorative pieces, cur-
tains, etc. Additionally, the bristle separates even the most resistant dirt from the surface.
REPLACING THE DUST BAG
To replace the dust bag, turn off the vacuum cleaner with the power switch (1) and disconnect
it from the power source. Remove the suction pipe (21) and press the (8) button to open the
upper cover (9). Remove the dust bag support (16), remove the old bag from the support and
insert a new one. The support can be placed in the vacuum cleaner in one position only. Close
the cover (9) and connect the suction pipe (21).
AIR FILTER CLEANING AND REPLACEMENT
Normal use of the vacuum cleaner requires periodical replacement or cleaning of the air filter,
which protects the motor from the side of the dust bag, and the air outlet filter. For this purpo-
se, disconnect the appliance from the power supply and detach the suction pipe.
1. Press two buttons located on the motor cover (19) simultaneously, remove the cover and
remove the sponge (18). Remove the HEPA filter (17) as well.
2. Remove the motor filter (14). You will access the filter by lifting the cover (9) and removing the
dust bag (15). Lift the filter grate up. When removed, remove the filter sponge (14).
3. Clean the HEPA filter of dust. In the case of a considerable amount of dust, rinse the filter in
cool water. The HEPA filter must be perfectly dry before installing it again. Wash filter cartrid-
ges (14 and 18) under running and cool water. Dry the filters thoroughly after washing.
4. Cartridges should be cleaned every month or more frequently (depending on the usage). If a
cartridge is too contaminated or damaged, replace it with a new one.
5. When installing the filter elements, carefully align them in the housing and the vacuum
cleaner.
CAUTION: The filter cartridge being mounted must be completely dry. Mounting a wet filter may cause an
electric shock.
CLEANING AND MAINTENANCE
1. Periodically clean the vacuum cleaner housing and other external elements with a damp
cloth. This will allow maintaining good appearance of the appliance.
2. For this purpose, do not use sharp objects or any strong detergents (e.g. solvents), as this will
cause permanent damage to the vacuum cleaner housing.
3. For air filters and dust bag, follow the above instructions.
To Next Page
Loading...
Need help?
General
