MPM MOD-36 User Manual

16
EN
ASSEMBLY OF THE VACUUM CLEANER
1. Insert the mesh filter (12) into the dust container – make sure that the three tabs on the outer
ring of the filter take their places in the dust container.
2. Place the motor filter (11) on the mesh filter (12).
3. Fit the dust container lid onto the container and twist it slightly – mind the markings on the
container.
4. Insert and lock the dust container in the motor module, note that the container at the bottom
has a hook which must catch on the corresponding part in the motor module; then press the
container against the motor module (fig.4).
5. Connect the suction pipe (17) or the appropriate equipment directly to the suction pipe sock-
et (16) (fig.5). Removal of the pipe or equipment is only possible by pressing the lock release
button (18), (20) or (23).
CAUTION! Do not operate the vacuum cleaner when it is not assembled!
CHARGING THE BATTERY
CAUTION! Charge the battery before using the vacuum cleaner for the first time. The time required to charge
the battery is approximately 3.5 – 4 hours.
hook
slot
Fig. 4
klik klik
Fig. 5

MPM MOD-36 Specifications

General

Brand	MPM
Model	MOD-36
Category	Vacuum Cleaner
Language	English