23
6. PARALLEL CHARGING FUNCTION
This function is only applied to use “MPPTracker” software to control multiple chargers
with Modbus or SNMP interface at the same time. Users can assign chargers in
different groups. Refer to below chart for software setting screen. Chargers assigned in
the same group will be parallel charged to the same batteries. After assignment,
simply click “Enable” or “Disable” to activate parallel charging function. You can check
more details from “MPPTracker” user manual.
Setting conditions
1. Computer setting
It’s necessary to use computer running “MPPTracker” software to synchronize actions
of all chargers.
2. Equipped with Modbus or SNMP communication
Each charger must be connected with Modbus or SNMP card to have communication
with computer.
3. Each charger should be connected to solar panel separately.
4. Chargers assigned in the same group should charge the same battery.
To Next Page
Loading...
Need help?
General