To Next PageTo Next Page
Need help?Do you have a question about the mPTech myPhone Halo C and is the answer not in the manual?
General| Brand | mPTech |
|---|---|
| Model | myPhone Halo C |
| Category | Cell Phone |
| Language | English |
Do not use phone while refueling or near chemicals; turn off in explosion risk areas.
Alarm calls may not be possible; find alternative methods for emergency services.
Only qualified personnel or authorized service center may install or repair the product.
Device not for unsupervised use by children or people with limited abilities; keep out of reach.
Do not use the device while driving any kind of vehicle.
Protect device from water and other liquids to prevent damage.
Avoid extreme temperatures, damage, and improper disposal of batteries and accessories.
Avoid hearing damage by not using high volume for long periods or placing device directly to ear.
Avoid eyesight damage by not looking closely at the diode; strong light can cause permanent eye damage.
Allows receiving calls or viewing call list.
Navigate menus and launch shortcuts on the main screen.
Press to enter phonebook; exit or opt out of menus.
Reject calls; return to main screen; turn phone on/off.
Lock/unlock phone, decrease volume, insert symbols in SMS.
Switch audio modes, change input modes, increase multimedia volume.
Turn the flashlight diode on or off at any time.
Accesses the camera lens.
Activate alarm or auto-dial predefined numbers by pressing and holding.
Loudspeaker for system sounds, ringtones, and music.
Dial numbers, enter letters/numbers in SMS writing mode.
Diode used as a torch.
Connect phone to the charging base.
Enables battery recharging and data transfer when connected to computer.
Allows taking off the phone cover.
Ensure the SIM card is installed correctly.
Enter PIN when turning on phone if SIM is secured.
Ensure the phone is on and within GSM network reach.
Move to another location if signal or reception is weak.
Make sure the speaker and microphone are not covered.
Check mic/speaker coverage and headset connection.
Verify typed phone number and contact entries are correct.
