1 Introduction
Maschinenfabrik Reinhausen GmbH 20186 1800059/09 ENRS
The following documents are considered supporting documents:
▪ Supplements (included in the scope of delivery)
▪ Dimensional drawing (included in the scope of delivery)
▪ Routine test report (included in the scope of delivery)
Also observe generally valid legislation, standards, and guidelines as well as
specifications on accident prevention and environmental protection in the re-
spective country of use.
1.5 Safekeeping
Keep this technical file and all supporting documents ready at hand and ac-
cessible for future use at all times.
1.6 Notation conventions
This section contains an overview of the symbols and textual emphasis
used.
1.6.1 Hazard communication system
Warnings in this technical file are displayed as follows.
1.6.1.1 Warning relating to section
Warnings relating to sections refer to entire chapters or sections, sub-sec-
tions or several paragraphs within this technical file. Warnings relating to
sections use the following format:
WARNING
Type of danger!
Source of the danger and outcome.
► Action
► Action
1.6.1.2 Embedded warning information
Embedded warnings refer to a particular part within a section. These warn-
ings apply to smaller units of information than the warnings relating to sec-
tions. Embedded warnings use the following format:
DANGER! Instruction for avoiding a dangerous situation.
To Next Page
Loading...
