Unpacking and Handling
Remove the shelves and runners from the packaging before attempting to move the equipment
When unpacking and handling the product, always lift it by its base. Do not use the door or any other
projecting cover or component to support the equipment when moving it. Use two or more people to
carry the product where possible
Carefully remove any packing material from inside and around the product before use. Avoid damaging
the surrounding insulation when removing packing materials
Locate the shelves and runners as required
Siting and Setting Up
Place the product on a level surface in a well ventilated area
Site away from other sources of heat and on a non-flammable surface that is resistant to accidental
spillage or hot materials
The surface on which the equipment is mounted should be stable and not subject to movement or
vibrations
The height of the mounting surface is important to avoid operator strain when loading and unloading
samples
Unless otherwise stated elsewhere in this manual, ensure that there is at least 150 mm of free space
around the back and sides of the product. Clear space is required above the product to dissipate heat
General Overview
Ensure that the product is placed in such a way that it can be quickly switched off or disconnected from the
. electrical supply
.
Some models have protruding fan motor housings: these housings must be in an area of good ventilation
To Next Page
Loading...