mrcool.com 16
16
OUTDOOR UNIT INSTALLATION
5
Keep in mind that the hooks on the mounting plate are smaller than the holes on the back of the unit.
Ifyoundthatyoudonothaveampleroomtoconnectembeddedpipestotheindoorunit,theunit
can be adjusted left or right by about 1.25 in -1.95 in (30 mm - 50 mm), depending on the model. (See
Fig. 4.10)
UNIT IS ADJUSTABLE
5.1 Installation Location
Before installing the indoor unit, you must choose an appropriate location. The following are standards that will
help you choose an appropriate location.
Step 1: Select Installation Location
Proper Installation Locations Meet the
Following Standards:
DO NOT install unit in the following
locations:
; Meets all spatial requirements shown in Installation
Space Requirements (Fig. 5.1).
; Good air circulation and ventilation.
; Firm and solid location that can support the unit
and will cause vibration.
; Noise from the unit will not disturb others.
; Protected from prolonged periods of direct sunlight
or rain.
; Where snowfall is anticipated, raise the unit above
the base pad to prevent ice buildup coil damage.
Mount the unit high enough to be above the
average accumulated area snowfall. The minimum
height must be 18 inches.
ǿ Near an obstacle that will block air inlets and
outlets
ǿ Near a public street, crowded areas, or where
noise from the unit will disturb others
ǿ Near animals or plants that will be harmed by
hot air discharge
ǿ Near any source of combustible gas or in a
location that is exposed to large amounts of
dust
ǿ In a location exposed to a excessive amounts
of salty air
To Next Page
Loading...
