MrCool Advantage Series - Electrical Safety Warnings

mrcool.com3
SAFETY
1
ELECTRICAL WARNINGS
****ELECTRICAL WORK MUST BE COMPLETED BY A QUALIFIED ELECTRICAL TECHNICIAN****
DO NOT share the power supply with other appliances. You must use an independent circuit to
 supplypower.Animproperorinsucientpowersupplycouldcausereand/orelectricalshock.
1. Only use the specied power cord. If the power cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualied persons in order to avoid a hazard.
2. Do not modify the length of the power supply cord or use an extension cord to power the unit.
3. Appropriate wiring standards, regulations, and the installation manual must be followed for all electrical
work.
4. If connecting power to xed wiring, an all-pole disconnection device must be incorporated in the xed
wiring in accordance with the wiring rules and must meet the following requirements: at least 1/8" (3 mm)
of clearances in all poles, a leakage current that may exceed 10 mA, and a residual current device (RCD)
having a rated residual operating current not exceeding 30 mA.
5. For all electrical work, fuse the specied cables. Connect cables tightly and clamp them securely to prevent
external forces from damaging the terminal. Improper electrical connections could overheat, causing re
and/or electrical shock.
6. All wiring must be properly arranged to ensure that the control board cover can close properly. If the
control board cover is not properly closed, it can lead to corrosion and cause the connection points on the
terminal to heat up, catch re, or cause electrical shock.
NOTE ON FLUORINATED GASES (NOT APPLICABLE FOR R-290 UNITS):
1. This unit contains uorinated greenhouse gases.
2. For specic information on the type of gas and the amount, please refer to the relevant label on the unit
itself.
3. Service, maintenance, and repair of this unit must be performed by a certied technician.
4. Product un-installation and recycling must be performed by a certied technician.
5. If the system has a leak-detection system installed, it should be checked for leaks at least once per year.
When checking the unit for leaks, maintain proper record-keeping of all checks.
6. For equipment that contains uorinated greenhouse gases in quantities of 5 tonnes of CO2 equivalent
or more, but less than 50 tonnes of CO2 equivalent, if the system has a leak-detection system installed, it
must be checked for leasts at least once every 2 years.
CAUTION
DO NOT install the unit in a location that may be exposed to combustible gas leaks. If
 combustiblegasaccumulatesaroundtheunit,itcouldcausere.
DO NOT install a unit equipped with an auxiliary electric heater within 3 ft (1 m) of any
combustible materials.
DO NOT operate the unit in a room where it could be exposed to excessive amounts of water,
such as a bathroom or laundry room. Exposure to excessive water amounts can cause the
electrical components to short circuit.
1. Install the drainage piping according to the instructions in this manual. Improper drainage could cause
water damage to your home and/or property.
2. The product must be properly grounded during installation or electrical shock could occur.